About The Power Adapter Common Sense
Sep 03, 2018| 1. There is abnormal noise during operation, the power indicator and the charging indicator are dark and flashing
The cause of the malfunction is that the IC1 is damaged. Be careful when replacing it. Do not damage the copper foil of the printed board. After the replacement is normal, adjust the R28 so that the output voltage of the charger is within the normal working range.
2. There is an abnormal sound when working, and there is no charge.
Check if there is any solder joint or damage on C8 on the circuit board. Generally, replacing C8 can solve it.
3. Large heat and abnormal noise
The cause of the fault is caused by damage to the output stage damping resistance R31 and C17. In addition, C12 open circuit or virtual soldering can also cause the above faults.
4. Severe fever, even burning deformation of the outer shell
This is mainly caused by the failure of some users to carry some components and loose parts. The main performance is as follows: When C18 looses the virtual welding, it will cause the working state of V1 and V2 to be abnormal. The heat is very large. When the battery case is deformed seriously, the circuit board is burnt, causing V1 and V2 damage. C18 can be re-welded and checked. V1, V2, R4, R7. If the fault cannot be eliminated, check whether there is an open circuit in D15 and D21. In addition, some manufacturers use a double diode for the output rectifier. One of the open circuits also causes the above fault. Sometimes the fault will cause V1 and V2. One is damaged. Check and replace at the same time.


