How to repair the broken data cable

First, place the rope under the data line to be repaired, and place the left end of the rope under the right rope after crossing the top of the data line.

Second, thread the right end of the rope under the data line and out over the left end of the rope. The whole process is equivalent to tying a knot, where you tie the data wire inside the knot and then tighten both ends of the rope.

The third step, the right side of the rope from above the data line, put it under the left side of the rope, and then the left side of the rope from below the data line, from the right side of the rope. Remember the orientation and arrange it so that the knots on each side are symmetric.

The fourth step, repeat the second and third steps repeatedly, the length of the weave can be increased or reduced according to the degree of data cable damage, and then cut off the excess part, burn it with a lighter, so that it has a knot.

This method is not only suitable for data lines, if there are other wire damage in the home, such as electric hair dryer, with this weaving method can repair the damage, but also make it beautiful, prolong the service life.